Skip to Main Content

Tech To-Go

Using some of OSUIT's Tech To-Go? Check here for operating instructions, checkout policies and more!

Beats Studio Over Ear Headphones

Operating Instructions

 Click the manual icon for access to operating instructions for Beats Headphones.

 

Equipment List

Required Equipment:

  • Beats Studio Headphones in carrying case
  • USB charging cord and AC wall adapter
  • Headphone cord
  • Headphone/microphone cord for use with a smart phone
  • Carrying case

Quick Start Guide

Power Button

  • Hold to turn on or off
  • Power LED will glow white when on
  • Tap button to show Fuel Gauge status

To Charge

  1. Connect charging cable to micro USB port on right earcup
  2. Connect the USB-end of cable to a power source

It takes about 2 hours to fully charge a dead battery using the AC adapter. It may take longer if you’re charging via USB from your laptop or other device.

If your headphones aren’t charging properly, reset your Studios.

Battery Status

Here’s what the blinking LEDS on the Fuel Gauge mean:

When unplugged from power source:

  • 5 white lights signal full or near-full charge
  • 1 solid red light signals low charge
  • 1 flashing red light signals battery is near depletion
  • No lights signal headphone is powered off or battery is not charging

When plugged into power source:

  • 5 white lights signal maximum charge
  • 1 flashing white light signals battery is near depletion

Wireless Features

Pairing

  1. Turn your headphones ON
  2. Ensure that there is no audio cable plugged into your headphones
  3. The Bluetooth LED on the left earcup will blink, indicating that you are in pairing mode
  4. Connect to your headphones with your phone or music player
  5. The Bluetooth LED will blink four times to confirm a connection has been made and will remain on

To manually initiate pairing mode, press and hold the b button for 2 seconds.

Disconnect & Reconnect

  • Push and hold the b button to disconnect your Bluetooth connection.
  • To re-pair to your last Bluetooth connected device, press and release the b button.

ANC-Only Mode

Enable ANC-Only Mode by pressing and holding the power button and the b button for 1 second.

Music Controls

Press and release the b button to play or pause music

Play it Forward

  • Press the b button twice to skip to the next track
  • Press the b button twice and hold on the second press to scan forward

Take it Back

  • Press the b button three times to play the previous track
  • Press the b button three times and hold on the third press to scan backward

Taking Calls

  • Answer or end a call—single button press
  • While on an active call, double press to take the call from your phone rather than your headphones
  • To reject an incoming call, press and hold the b button for 2 seconds

Item Policies

Loan Period: 3 Days

Special Instructions:

  • OSUIT is not responsible for your hearing loss. Keep your music at a reasonable volume, and preserve your eardrums. :-)